How to Fix Drafty Windows: Find the Leak and Seal It Before Winter

Nov 5, 2026

Light a stick of incense on a gusty night and hold it a few inches from the bottom of your bedroom window. If the smoke bends toward the room or flutters sideways, you have found a draft (and the reason that corner of the house never feels warm).

Once the fall storms roll in, drafty windows become one of the top complaints in South Puget Sound homes. The thermostat says 68, the couch by the window feels like 60, and the furnace keeps kicking on. Most people blame the glass. Usually it’s a worn strip of weatherstripping, a split bead of old caulk, or a sash that doesn’t close tight anymore.

Left alone, those small gaps add up. Energy Star calls air sealing and insulation two of the most cost-effective ways to improve a home’s efficiency and comfort, and a leaky window on a wind-exposed wall in Bremerton or on a Tacoma hillside pulls warm air out all winter. Water can follow the same path in, which is how sills soften and paint starts to peel. If you know how to fix drafty windows (and when a window is past fixing), you can skip a cold winter and a bigger repair bill down the road.

Why Are My Windows Drafty?

Drafty windows: old aluminum slider with a gap at the sash and cracked weatherstripping

Drafty windows let air in around the sash, through the frame, or between the frame and the wall. The usual causes are worn or compressed weatherstripping, cracked exterior caulk, sashes that no longer lock tight, frames that shifted as the house settled, and on older wood windows, gaps from shrinkage or rot.

Glass rarely lets air through, so drafty windows almost always leak at the edges. What you feel as a “cold window” is usually one of two things, and the fix depends on which one you have:

  • Air leakage. Outside air moves into the room through gaps. You can feel it on your hand, and a candle flame or incense smoke will bend.
  • Radiant cold. Single pane or early double pane glass gets cold and pulls heat from your body when you sit near it. Cold glass also chills the air beside it, which sinks and spills across the floor, so you can feel a draft even when no outside air gets in.

Air leakage is easier to solve, and it’s what most people mean when they say drafty windows. Radiant cold usually means the glass is due for an upgrade.

The most common leak points on drafty windows:

  • Weatherstripping. Foam, felt, vinyl, and bulb seals around the sash compress and crack after years of opening and closing.
  • Caulk joints. The sealant between the window frame and the siding or trim shrinks and splits after enough sun and rain.
  • Sash locks and balances. On single and double hung windows, a worn lock or a weak balance lets the sash sag, which opens a gap at the meeting rail where the two sashes overlap.
  • Frame movement. Houses settle. A frame that goes out of square leaves the sash unable to seal on one side.
  • Wood shrinkage and rot. Older wood windows dry out, shrink, and eventually soften where water sits on the sill.

How Do You Find a Window Draft?

Incense smoke drifting sideways at a drafty window, showing where cold air leaks in

To find a window draft, pick a cold, windy day and test each window with a lit incense stick, a candle, or a damp hand along the sash, the meeting rail, and the frame edges. Then check the outside for cracked caulk. A thermal camera or a professional blower door test pinpoints leaks you cannot feel.

Go one window at a time and jot down what you find; drafty windows often leak in more than one spot. Try this order:

  1. Close and lock the window. Many drafts disappear once the lock pulls the sash tight against its seals.
  2. Run the smoke test. Move incense slowly around the sash and the frame. Watch for the smoke to pull or flutter.
  3. Try the paper test. Close a sheet of paper in the sash and tug it. If it slides out with no resistance, the weatherstripping is not making contact.
  4. Inspect the outside. Look for gaps where the frame meets the siding or trim, and for caulk that has pulled away or cracked.
  5. Look for light. On a bright day, darken the room and check for daylight around the edges of the sash.

For a whole-house picture, book a home energy audit with a blower door test. The auditor uses a powerful fan to pull air out of the house, which exaggerates every leak so it shows up on a thermal camera. Energy Star’s problem-to-project chart pairs drafty rooms and high heating bills with the air sealing jobs most likely to fix them.

How to Fix Drafty Windows: 7 Fixes That Work

Applying exterior caulk where window trim meets siding to seal drafty windows

The fastest ways to fix drafty windows are to lock the sash, replace worn weatherstripping, and recaulk exterior gaps. Next come removable caulk and insulating film for windows you rarely open, then hardware repairs, and finally sash or full window replacement when the frame itself is failing. Start with the simplest fix that matches the leak you found.

Seven solutions for drafty windows, from quickest to most involved:

  1. Lock every window. On hung and sliding windows, the lock pulls the sashes together and squeezes the seals. It costs nothing, so start there.
  2. Replace the weatherstripping. Pull the old strip and match its profile. V-strip, a folded tension seal, suits the sides of hung sashes, while foam tape or rubber bulb seal works where a sash closes against a stop.
  3. Recaulk the exterior. Cut out cracked caulk where the frame meets the siding and trim, then run a fresh bead of exterior-grade sealant. Leave the weep holes at the bottom of the frame open; they let water drain out.
  4. Seal the interior trim. A thin bead of paintable caulk where the interior casing meets the wall and the frame slows air that sneaks around the window through the rough opening. For a larger gap, pull the casing, fill the space between the frame and the wall framing with low-expansion window and door foam, then reinstall the trim. Energy Star’s trim sealing project guide walks through the steps.
  5. Use removable caulk or insulating film. For a window you never open in winter, removable rope caulk or a shrink film kit blocks air and adds a layer of still air. Both peel off in spring.
  6. Repair the hardware. Replace worn locks, tilt latches, and balances so the sash sits square and closes tight.
  7. Replace the sash or the window. When the frame is rotted, out of square, or the glass has failed, sealing the edges only buys time. A new window restores a factory seal around the whole unit.

Heavy curtains and cellular shades help with radiant cold at night, but air still gets past them. Sealing drafty windows at the edges stops the air, so use curtains alongside the fixes above.

Fix Comparison at a Glance

FixBest forDIY difficultyHow long it lasts
Locking the sashHung and sliding windows with a gap at the meeting railEasyAs long as the lock works
New weatherstrippingAir leaks around a sash that opensEasy to moderateSeveral years, depending on use
Exterior caulkGaps between the frame and siding or trimModerateSeveral years with good prep
Removable caulk or filmWindows that stay closed all winterEasyOne season
Hardware repairSagging sashes, worn locks or balancesModerateMany years
Window replacementRot, failed glass, or a frame out of squareProfessionalDecades with proper installation

When Should You Replace Drafty Windows Instead of Repairing Them?

Installers removing a drafty old aluminum window before setting a new vinyl replacement window

Replace drafty windows when the draft comes from the window itself: soft or rotted wood, a frame out of square, or single pane glass. Weatherstripping and caulk close gaps at the edges, but they cannot fix a window that has stopped holding its shape or its insulating value.

Signs that a repair will not hold:

  • Soft wood at the sill or bottom rail. Press with a screwdriver. If the tip sinks in, moisture has done structural damage.
  • Fog or haze between the panes. That means the insulated glass seal has failed. Fog does not cause a draft, but the glass has lost insulating value, and on a sound frame replacing only the glass unit is often an option. Our post on condensation on windows explains how to tell seal failure from ordinary room humidity.
  • Sashes that stick, bind, or will not lock. A frame that has racked out of square leaves a gap no seal can close.
  • Single pane glass. Even an airtight single pane window loses heat fast, so sealing it will not make the room feel warm.
  • Repeat repairs. If you recaulk and restrip the same window every fall, the window is near the end of its life.

Manufacturers build and test new windows as sealed units. When the manufacturer lists it, the air leakage rating on the NFRC label shows how much air passes through the window under test conditions, and a lower number means a tighter window. Energy Star certified windows have to meet an air leakage limit along with their U-factor and SHGC requirements. Our post on Energy Star Most Efficient windows walks through how to read those numbers.

What Makes Drafty Windows Worse in South Puget Sound Homes?

Older South Puget Sound home on a bluff above the water, exposed to wind and rain

Drafty windows get worse in South Puget Sound homes during fall and winter, when wind-driven rain, a long heating season, and damp air wear out seals and caulk. Homes near the water in Bremerton, Gig Harbor, and along the Tacoma shoreline take the most wind, and older homes in Lakewood and North Tacoma often still have original windows.

Three local patterns to check:

  • South and southwest walls. Winter storms here usually blow in from the south and southwest, so the caulk and seals on those walls tend to fail first.
  • Older aluminum windows. Many homes built through the 1970s still have single pane or early dual pane aluminum sliders. Aluminum conducts heat quickly, and the pile weatherstripping on old sliders wears flat.
  • Water at the sill. Rain that gets past a failed seal sits on the sill. Over a few winters, a draft can turn into rot.

The fix list for drafty windows is the same here. What changes is the timing. Most exterior caulks need a dry surface and a minimum temperature (check the tube, but 40 degrees is a common floor), so plan to seal drafty windows from the outside in early fall or during a dry stretch of weather.

Should You Hire a Pro to Fix Drafty Windows?

Hire a professional when the draft comes from the frame, the glass, or the gap between the window and the wall, or when the window sits on an upper floor. Weatherstripping and interior caulk make good weekend projects. Diagnosing rot, replacing hardware on older units, and installing new windows call for experienced, AAMA-certified installers.

How do you fix drafty windows when the problem goes deeper than a worn seal? Get someone out to look at it. A specialist can tell you whether a window is worth repairing at all, so you don’t sink money into a frame that’s about to fail. If you do replace it, the installer flashes and seals the new window into the wall, and that joint is where a lot of leaks start. They can also match the glass package to the sun and wind on that side of the house.

If you are weighing a bigger project, our article on window replacement in Tacoma covers what to expect, and our promotions and rebates page lists current offers.

Stop the Draft With Sound Glass

Sound Glass logo

Some drafty windows need an afternoon and a tube of caulk. Others are worn out and due for replacement. Sound Glass has served homeowners across Tacoma, Bremerton, Lakewood, and Pierce, Kitsap, King, and Mason counties since 1983.

Our AAMA-certified specialists can look at your windows and help you choose a replacement from our full line of residential windows. If the cold spot is a patio or front door, we handle entry and French doors too. Learn more about our team on our About page, then contact Sound Glass to schedule a consultation before the next storm rolls in.

Frequently Asked Questions

How do I fix drafty windows without replacing them?

Lock the sash, replace worn weatherstripping, and recaulk the gaps between the frame and the siding or trim. For windows you keep closed all winter, removable rope caulk or a shrink film kit blocks air for the season. These fixes handle most edge leaks, but they cannot repair rot or failed glass.

What is the best weatherstripping for drafty windows?

The best weatherstripping depends on where the sash seals. V-strip tension seals suit the sides of double hung sashes, foam tape and rubber bulb seals work where a sash closes against a stop, and pile weatherstripping fits sliding windows. Match the profile of the original seal so the window still closes and locks.

Can new windows still be drafty?

New windows can feel drafty if the installer skipped proper flashing and sealing between the frame and the wall, or if the sash is not locked. Energy Star certified windows must meet an air leakage limit, so a noticeable draft from a new window usually points to an installation gap that an installer can find and seal.

Is it worth replacing windows because of drafts?

Replacing windows makes sense when drafts come from rot, a frame out of square, or single pane glass. If the frame is sound, new weatherstripping and caulk are the better first step. A window specialist can inspect the frame and tell you which situation you have.

Why is my window drafty even when it is closed and locked?

A closed, locked window that still leaks usually has compressed weatherstripping, cracked caulk at the exterior trim, or a gap between the frame and the rough opening behind the interior casing. Run a smoke test around the sash and the trim to find the path, then seal the spot where the smoke moves.